The GW2 Series

The GW 2 SERIES is primarily for machining non-ferrous alloys.
  • 2 Flutes
  • Allows for faster feed rates without chip packing and can be used for plunge, ramp or profile milling.
  • LONG (GWL) & EXTRA LONG (GWXL) end mills are standards.
  • Available AlTin coated (other coatings available upon request)
  • 10% micro grain carbide
  • Regrind and recoating available upon request
  • Center Cut

The GW2 Series

$11.76$405.76

$11.76$405.76
Coating AlTiN NONE
Cutting Diameter 0.0312 0.0625 0.0937 0.125 0.1562 0.1875 0.2187 0.25 0.2812 0.3125 0.375 0.5 0.625 0.75 1
End Type R.01 Corner Radius R.02 Corner Radius R.03 Corner Radius R.06 Corner Radius R.09 Corner Radius R.125 Corner Radius R.187 Corner Radius Square End
Length Extra Long Long Standard Stub
Length of Cut 0.078 0.125 0.188 0.25 0.312 0.31255 0.375 0.4375 0.5 0.625 0.75 0.812 0.875 1 1.125 1.25 1.5 1.625 1.75 2 2.25 3
Clear selection
Clear

See Tool Specs & Variations

SKULengthLength of CutCutting DiameterEnd TypeCoatingStockPriceQuantityAdd to Cart
103827Stub0.0780.0312Square EndNONE14$14.52
107269Stub0.0780.0312Square EndAlTiN11$17.25
101528Stub0.1250.0625Square EndNONE56$15.74
107121Stub0.1250.0625Square EndAlTiN0$18.40
103928Stub0.1880.0937Square EndNONE4$11.76
107270Stub0.1880.0937Square EndAlTiN0$14.49
101529Stub0.250.125Square EndNONE1$12.20
107271Stub0.250.125Square EndAlTiN0$14.94
103931Stub0.312550.1562Square EndNONE5$15.83
109158Stub0.312550.1562Square EndAlTiN0$20.45
102471Stub0.3750.1875Square EndNONE9$16.27
109160Stub0.3750.1875Square EndAlTiN0$20.92
103935Stub0.43750.2187Square EndNONE0$21.29
109161Stub0.43750.2187Square EndAlTiN0$26.63
103566Stub0.50.25Square EndNONE7$21.78
106971Stub0.50.25Square EndAlTiN0$27.25
103938Stub0.50.2812Square EndNONE4$25.34
109162Stub0.50.2812Square EndAlTiN0$30.74